Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. South Mountain Roofing & Maintenance — leak-free skylight installation in South Mountain.
The curb is the foundation of every skylight installation. We frame it between existing trusses or rafters with doubled lumber to carry the load. The roof deck opening is cut precisely — no oversizing that weakens the sheathing. The skylight flange seals to the curb, and the flashing system integrates the unit into the existing shingle field so water runs over the flashing, not under it.
Our Skylight Installation Process
Site Assessment
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Structural Prep
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Seal Integration
Self-adhering ice-and-water shield on all curb faces. Step flashing along both sides lapped under each shingle course. Head flashing at the top, apron flashing at the bottom. Waterproof sealant at every overlap and transition. The flashing makes or breaks the installation.
Final Seal & Trim
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What South Mountain Customers Say
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
Why Choose South Mountain Roofing & Maintenance for Skylight Installation?
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.
Code Compliant
Every skylight installation meets PA building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.